We now supply a pre-made wiring loom kit to suit the Flyleds kit. The kit contents include:
20ft of (M27500/22SB2T23 Tefzel) two wire shielded cable for the tail light
23ft (x2) of (M27500/22SB3T23 Tefzel) three wire shielded cable for each wing
6 feet each of (M22759/16 Tefzel) Black/Yellow/Red/White 18AWG for power and ground into the control board.
Terminated at the controller board end using machined crimp pins.
The wire lengths above are long enough (and then some) for an RV-10.
If you are ordering The Works kit we will include a 50ft length of 18AWG wire for the landing lights as well. (This should be enough to cover the wing runs and the connections from the controller board to your panel switches).
The far end of each wire run will be left un-terminated so that you can run the wires through your plane and trim to length.