Get premium-quality LED lighting for less with these DIY kits. Build your own wingtip LED strobe and position lighting in a few hours for way less!
DIY Kit- Built by you. You need to solder all of the components onto the boards.
It should only take you 4 to 5 hours to complete.
You only need basic hand tools like flush or side cutters and pliers (~$10 each), but you must have a temperature controlled soldering iron with a fine point tip. Even something like the cheapy from this selection will do the job. (However, your 200w soldering iron you use to fix holes in your roof won't be suitable!) We have included a length of solder in the kit for you.
Step by step instructions are provided, so even if you're a beginner at soldering, we'll walk you through every step.
These lights are designed to exceed the minimum anti-collision lighting requirements for certified aircraft; you will be seen with Flyleds' LED position and strobe lights.
The strobes are switch-configureable for several flash patterns.
In addition, an optional WigWag mode is available, which gives a longer flash duration and improves your visibility to others during daytime flight.
450grams/16 oz total weight. (That's only 200 grams/7 oz per wing!)
The kit includes left and right wing boards, the controller board, and all of the parts required to make it bright! You can complement this kit with our LED tail strobe.
Already have wingtip landing lights installed? Sub out for our Skinny boards
in your kit and keep your setup intact.
We now have boards to suit:
RV-10&14 (Van's part number W-1015)
RV-7 & 8 (W-715-1 Newer model wingtips with a straight trailing edge )
RV-7 & 8 (W-715 "Batwing" Older model wingtips with a curved trailing edge)
RV-4, 6, & 8 (W-415 Flat-top or Hoerner wingtip).**contact us for availability
COMING SOON: Boards to suit
Simply select your wing type at checkout and we'll send you the correct ones.
Appropriate instructions will come with your kit, but you can find all instruction manuals at http://flyleds.com/info
Note: Not supplied with kit:
Shielded 18-22 AWG cable to connect the wings and tail light to the controller board.
We do supply a solder type 15 pin male D connector for your wiring loom, however, we recommend that you replace this part with a crimp style plug and machined crimp pins.